Ethernet interface

With this Option, Technix Power Supplies can be remotely controlled with with a TCP/IP protocol through an Ethernet interface. This interface is available on the rear panel of the power supply. Connection to the power supply is managed through a RJ45 connector.

Request a quote

Main specification Detailed specification Interfaces Products

MAIN SPECIFICATION

Two configurations are possible:

With a virtual series communication port
Raw Ethernet mode

Ethernet features:

Labview runtime available (option)
Optical fiber (option)
Full duplex mode
Bauds rate: 9600
ASCII protocol
12 Bits resolution
Communication frequency: 10Hz

Detailed specification

Instructions available on the Ethernet interface:

Output Voltage setting
Output current setting
Output voltage measurement
Output current measurement
HV-On control
HV-Off control
Remote control
Inhibit control
Mains Monitor
Regulation mode status
End of Charge status
Fault status
Interlock status
HV-On status

Interfaces

Complementary interfaces

Ethernet Optical Fiber Interface

Products

Complementary products

SR up to 16kV Power up to 2kW SR up to 150kV Power up to 2kW SR up to 150kV Power up to 40kW SR up to 70kV Power up to 40kW CCR up to 60kV Power up to 40kJ/s CCR up to 150kV Power to 20kJ/s CCR up to 16kV Power up to 1kJ/s CCR up to 150kV Power up to 1kJ/s

You need
informations ?

Request a quote